LYNXTalk.se - "Skandinaviens största märkesinriktade snöskoterforum"

Will do that!
I may be able to do it tomorrow.
Yes, I have the 371x41-57mm track.
No clering issues when the brackets is installed. (BRP#860200637)

FYI...
The drop brackets will only work on a 2012.
I put a 59mm track on a 2011 Boondocker and to do this I used the stock rear brackets from
an 2012 Xtrim and relocated the front mount of the rear shock.

Here is the measurements. Red numbers is with the 57mm track- kit. Were the question mark is, i forgott to to write down de numbers, the number 227 pops up in my head. But im not sure. I may be able to measure it tomorrow again.



There is reinforcements at every attachment point. Youre able to see them in the picture.

Och så en lite update...

awesome, big thanks to you! This will give me what I want. If possible, please measure that missing dimension later so I get also that double checked.
I am doing this for 121 tunnel so I must fabricate rear brachets etc by myself. Anyway, not too much rush right now, this is how my sled looks like now

The Missing dimention is: 275mm

Det såg trångt ut under huven!
Går det inte att få bort buken på något smidigt sätt så att man kommer åt bättre?

Update igen...


Är hyffsat välfyllt med prylar där under. Buken är rätt lätt att ta lös, men jag kände aldrig att det behövdes....

Stoft skrev:Det såg trångt ut under huven!
Går det inte att få bort buken på något smidigt sätt så att man kommer åt bättre?

Lynxmann skrev:FYI...
The drop brackets will only work on a 2012.
I put a 59mm track on a 2011 Boondocker and to do this I used the stock rear brackets from
an 2012 Xtrim and relocated the front mount of the rear shock.

First, Sorry RannerKing to using your topic

Would you Lynxmann Please tell me more specs of your mods to the -11 Boondocker for fitting a BIG lugged track..
I would appreciate a few tips..
I almost bought the 2012 bracket kit but then i saw your post..
Planning to fit a 64mm and 41 wide PEAK Track for this and i WAS going to try fitting
the drop kit and lowering the middle "beam" where the rear shock front connects..
Pics??

Im sorry i dont have any pics of what i did because this was a customers sled. But basically i used the stock 2012 rear brackets on a 2011 sled. Whith the big lug kit for the 2012 the rear arm is moved a little foreward and the front mount for the rear shock is lowered and tilted a little down in the rear.
You can just use the measurements Rannerking have given to get it right exept you need to make sure it will clear the bigger track.